When calibration value "A" is set to desired number, press "SET" (underside) button to accept and put the computer into normal operation. Use "MODE" (top) button to raise calibration number, or "START/STOP" (front) button to decrease it. When total miles/km value is set to desired number, press "SET" (underside) button to accept and enter wheel calibration mode. Press "MODE" (top) button to adjust that digit. Use "START/STOP" (front) button to change which digit is flashing. Press "MODE" (top) button for two seconds to enter "odometer setting" (total km/miles) mode.
Press "MODE" (top) button to select "mph" (miles) or "km/h" (kilometers). Push all three buttons at once ("SET" button is on underside of unit.) Do this to clear the computer's memory after replacing the battery: If these buttons are further held down for more than 3 seconds, the wheel calibration value moves between "A" and "B" values.įor total reset. When the "START/STOP" (left) and "MODE" (right) button are pressed together in "ODO" mode, first the wheel calibration number appears. To select which weel calibration value to use: Press and hold the "SET" button for 2 seconds to switch back and forth between "A" and "B" calibration value. Press the "SET" button with a ballpont pen or similar tool.
Use "START/STOP" button to put into "stop" state (mile/h symbol not flashing.) To revise wheel size without losing mileage: If you hold the "SET" button for 2 seconds or more, you enter the mode to set the alternate ("B") calibration number. When calibration value "A" is set to desired number, press "SET" (recessed) button to accept. Note: This unit permits the entry of two different calibration numbers ("A" & "B") to allow the same computer to be used with different bicycles Use "MODE" (right) button to raise calibration number, or "START/STOP" (left) button to decrease it. When odometer value is set to desired number, press "SET" (recessed) button to accept and enter wheel calibration mode. Press "MODE" (right) button to adjust next digit. Use "START/STOP" (left) button to change flashing digit. Press "MODE" (right) button to enter "odometer setting" mode.
Use "START/STOP" (left) button to select "M" (miles) or "Km" (kilometers). Press "MODE" (right) button to enter distance scale selection mode. Push all three buttons at once ("SET" button is recessed on bottom of unit.) If you make a note of the odometer reading before changing batteries, you can re-enter the total distance reading after installing the new battery.
0 kommentar(er)
